Assembly And Setting Of The Orthoscoot; Nh1 To The User; Assembly Of The Orthoscoot ® Nh1 - ORTHOSCOOT NH1 Mode D'emploi

Assembly and setting of the ORTHOSCOOT

Assembly of the ORTHOSCOOT
The ORTHOSCOOT is delivered pre-assembled in a shipping carton. Only a few steps are required to put it into
®
opera tion, and these can be easily carried out by the user.
Put the handlebar into the handlebar shaft. Make sure
the silver bullet head locks in one of the position holes
L
34
®

R
ATTENTION: both axes
of the front wheels are
permanently marked with
a laser en graving. Please
observe the instruction
for assembly exclusively
on each side by all means!
Before assembling the
right front wheel, please
remove the safety cuff.

NH1 to the user

®
Close the upper quick-release lever to the fix handle-
bar. After having removed the ORTHOSCOOT
the packaging, the two front wheels are fixed at first.
For assembly, position the wheel to the steering
knuckle and push it up to the stop.
from
®
ORTHOSCOOT NH1
®