Turning On The Power; Connection Of Peripheral Devices; Initial Commissioning - KERN and SOHN DLB 160-3A Mode D'emploi

7.4.1 Turning On the Power

Supply balance with power via the mains power cable. The display lights up and the
equipment conducts a self-test. After completion of the test, the balance will set itself in
stand-y mode.
To switch on the display press the ON/OFF button. As soon as the weight display
appears, the instrument will be ready to weigh.

7.5 Connection of peripheral devices

Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the moisture analyser from the power supply.
Only use accessories and peripheral devices by KERN, as they are ideally tuned to the
appliance.

7.6 Initial Commissioning

In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. During this warming up
time the balance must be connected to the power supply (mains, accumulator or
battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.
16 DLB_A-BA-e-1714