Mains Connection - KERN and SOHN DLB 160-3A Mode D'emploi

5. Level the appliance with the help of
the foot screws until it is standing
evenly.
6. Connect the heater to the balance via
cable, insert the cable into the two
connectors on the rear of the
instruments as shown in the figure.

7.4 Mains connection

Power supply is provided via the supplied mains cable.
Check, whether the voltage acceptance on the scales is set correctly. Do not connect
the appliance to the power grid unless the information on the appliance (sticker)
matches the local mains voltage.
Important:
Does the labelling match the local mains voltage?
Do not connect if mains voltages are different!
-
If matching, connect the scales.
-
The moisture analyzer must be connected to a standard socket with earth terminal. Do
not eliminate the protective effect by using an extension lead without earth terminal. For
power supplies from power grids without earth terminals call a specialist to establish
equivalent protection according to the relevant installation regulations.
The power plug must be always accessible.
-
Before operating, check all cables for damage.
-
Guide the cables so that they cannot become damaged or interfere with the
-
measuring process.
DLB_A-BA-e-1714 15