JANE GRAND Instructions page 38

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
Adjusting the height of the headrest.
Once the integrated straps have been concealed, the height of the headrest
can be adjusted using the handle on the top part of the back of the headrest
(15). To unlock it, pull the button upwards, when you release it the headrest
will lock into the nearest position.
• Place the child on the booster seat, and adjust the height of the headrest
using the button (15). The seat belt should be slightly above the child's
shoulder.
6a
WARNING: Adjust the height as the child grows.
Installing the booster seat with backrest in the car with ISOfix anchors.
The booster seat can be secured with the ISOfix anchors, this gives the seat
more lateral stability. Do not use the Top tether anti-rotation strap for this
installation.
To install it follow the steps below:
• Extract the ISOfix anchors (6) by turning the handle (9) on the front of the
base.
7a
• Guide both anchors towards the Isofix connectors of your vehicle and press
until both sides are locked, two green signals on the sides of the base (8) will
show that both sides are correctly anchored. If one or both of the signals are
red, repeat this step.
7b
38
• Turn the handle (9) clockwise to fit the safety seat firmly against the backrest
of the vehicle seat.
7c
IM 1848.00 GRANDesp_.indd 38
Placing the child in the seat.
• Place the child on the booster seat, pass the vehicle shoulder belt through
the belt guide on the side of the headrest (11).
• Pass the seat belt over the child and fasten the buckle.
• Lastly, pass the belt under both armrests (10).
When taking the child out of the seat you don't need to take the seat belt
out of the guide on the headrest (11), so it is easier to fasten the child in again
next time the seat is used.
Adjusting the height of the headrest.
Once the integrated straps have been concealed, the height of the headrest
can be adjusted using the handle on the top part of the back of the headrest
(15). To unlock it, pull the button upwards, when you release it the headrest
will lock into the nearest position.
• Place the child on the booster seat, and adjust the height of the headrest
using the button (15). The seat belt should be slightly above the child's
shoulder.
6a
WARNING: Adjust the height as the child grows.
Removing the booster seat when it has been installed with ISOfix:
• Loosen the tension of the ISOfix anchors by turning the handle (9).
• Release the ISOfix anchors by pressing both unlocking buttons (7).
The signals on the side (8) will turn red.
• Remove the safety seat. You can store the ISOfix anchors inside the base by
turning the handle (9).
5a
5b
5c
16/09/15 17:51

Publicité

Table des Matières
loading

Table des Matières