Av Compu Link Remote Control System - JVC RX-D202B Manuel D'instructions

AV COMPU LINK
remote control
system
The AV COMPU LINK remote control system allows you to
operate JVC's video components (TV, DVD player*, and VCR)
through this receiver.
This receiver is equipped with the AV COMPU LINK-III, which has
added a function to operate JVC's video components through the
component video jacks. To use this remote control system, you
need to connect the video components you want to operate,
following the diagrams below and the procedures on page 33.
• Refer also to the manuals supplied with your video components.
* "DVD player" on pages 32 and 33 can be replaced with "DVD
recorder."
Connections 1: AV COMPU LINK connection
AV AV
COMPU LINK-III COMPU LINK EX
Monaural mini-plugs
(not supplied)
Monaural
mini-plugs
(not supplied)
IMPORTANT:
The AV COMPU LINK remote control system cannot control the
DBS tuner connected to the DBS IN jacks.
NOTES
• When connecting the receiver and a TV with the AV COMPU LINK
EX terminal by using a component video cable, you cannot use
Automatic selection of TV's input mode (see page 33).
• When connecting only the VCR and DVD player to this receiver,
connect it directly to the receiver using cable with the monaural
mini-plugs.
• You can connect only the TV with AV COMPU LINK EX or AV
COMPU LINK-III terminal to the AV COMPU LINK-III terminal.
32
TV
AV
COMPU LINK- III
AV
COMPU LINK
DVD player
AV
COMPU LINK
VCR
Connections 2: Video cable connection
This receiver is equipped with three types of the video terminals—
composite video, S-video, and component video, and the signals
coming into this receiver through one type of video terminals can
output only through the terminal of the same type. So you need to
connect the video components to this receiver using one of the
following three ways.
• When using the AV COMPU LINK remote control system, set
the video input for the DVD player and the VCR correctly (see
"Selecting the component video input mode—DVD VIDEO IN/
VCR VIDEO IN/DBS VIDEO IN" on page 20); otherwise, the
correct input for this receiver will not be selected on the TV.
Case 1:
When connecting the source equipment to the receiver
through the S-video terminals, connect this receiver to the
TV's video input 1 terminal using S-video cables.
S-video cable
Source
RX-D202B
equipment
Case 2:
When connecting the source equipment to the receiver
through the composite video jacks, connect this receiver
to the TV's video input 2 terminal (composite video input)
using composite video cables.
Composite video cable
Source
RX-D202B
equipment
Case 3:
When connecting the source equipment to the receiver
through the component video jacks, connect this receiver
to the TV's video input 2 terminals (component video
input) using component video cables.
Component video cable
Source
RX-D202B
equipment
S-video cable
TV
To video input 1
Composite video cable
TV
To video input 2
(Composite)
Component video cable
TV
To video input 2
(Component)