Cinderella Comfort NA Manuel De L'utilisateur page 13

Cleaning the Ventilation System
Recommended frequency: Annually or every 1000 uses
1. Unplug the toilet.
2. Pull the toilet away from the ventilation pipes and set it aside.
3. Using a hand-held brush with firm bristles, carefully clean any dirt, dust or other objects
obstructing the airflow from the horizontal inlet and outlet pipes.
4. Remove the chimney cap and the T-bend bottom cap from the vertical ventilation pipe.
5. Using a chimney sweeping brush, clean any built up material from the interior of the
vertical ventilation pipe.
Preparing Your Toilet for a Longer Period of Absence
In cases of longer periods of absence or risk of lightning strike, the plug should be disconnected from the power supply in or-
der to protect the toilet against external damage. Note! The waste must be incinerated and the yellow light switched off before
disconnecting the plug. If unburned waste remains in the toilet, this could cause great damage over time.
The battery will start charging when it is reconnected to the 230V power supply. The toilet should be stored dry, and to reduce
the external influences of temperature variations and moisture, it may be wise to disconnect the toilet from the pipes for
longer periods of absence. Remember to always reinstall the toilet before use.
Safety Backup Battery
Your Cinderella Comfort is equipped with a backup battery which is activated in the event of a power outage, for cooling down if
the toilet is hot. If the power remains out for longer periods of time, battery lifetime will be reduced.
Test the battery as follows:
1. Make sure that the toilet has been connected to the 230V power supply for at least 2 days, before checking the battery.
2. Unplug the toilet from the power supply.
3. Open and close the toilet lid, the text in display will indicate that the battery is functional.
4. If the battery is faulty, it must be replaced to ensure the safety of the toilet.
Language select
How to Select a Different Language on the
Cinderella Comfort Display
1. Hold down the "Language select" button for 3 seconds until "Language" is displayed on
the first text line. The current language will be displayed on the second line.
2. Push the ''Language select" button repeatedly until the desired language is displayed.
3. The new language will be saved a few seconds after you push the button, and the toilet will
resume operation.
English – User Manual Cinderella Comfort
13