Description Of The Hood & Controls; Controls; Description Of Control Panel - Elica OM EOM431BL Guide D'utilisation, D'entretien Et D'installation

Description of the hood &

Controls

1 Control panel
2 Grease filter
3 Grease filter release handle
4 Halogen lamp (Position and number of lamps may vary)
5 Front door
6 Air outlet (on top and on the rear side)
Controls
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.

Description of control panel

Light touch sensor key: dim lighting / full lighting /off
(loop control) - Works even with hood in stand
by/OFF
ON/OFF Intensive speed selection touch sensor
key (suction power) - lasts 5 minutes - press again to
return to previous setting.
High-speed selection touch sensor key (suction
power).
Medium-speed selection touch sensor key
(suction power) - when flashing it indicates the need
to wash or replace the carbon filter. This signal is
normally deactivated. Press sensor keys 1 and 2 at
the same time to activate. At first only key 1 will flash,
then both keys 1 and 2 to indicate activation. Repeat
the operation to deactivate the signal. At first keys 1
and 2 will flash, then only key 1 to indicate
deactivation.
Low-speed selection touch sensor key (suction
power) – when flashing it indicates the need to wash
the metal grease filter.
Motor touch sensor key OFF (stand by) – excludes
the electronics – reset wash/replace filters signals.
MOTOR OFF
Hood in stand-by: Press briefly to switch the motor
off.
RESET FILTERS SIGNALS
After having carried out maintenance of the filters,
press this sensor key for 3 seconds. Flashing led 1
(fats filter) or 2 (carbon filter) will stop flashing.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood command
electronics will be excluded.
This function can be useful during the product
cleaning operations.
Just repeat the operation to reinsert the electronics.
REMOTE CONTROL BATTERY CONTROL
When flashing, replace the battery on remote control.
Note: The front door must always be left closed and opened
only for maintenance (e.g. cleaning or changing filters).
If the hood fails to operate correctly, briefly disconnect it
from the mains power supply for almost 5 sec. by pulling out
the plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.
13