Operation; Switching The Radios On And Off; Channel Selection - switel WT108 Mode D'emploi

3

Operation

3.1

Switching the radios on and off

To switch on the radio, hold the POWER ON/OFF button pressed until
a signal tone sounds.
The display will be illuminated for some seconds and all the symbols
will be shown in the display. After this the display will show the
currently selected channel.
To switch the radio off again, hold the POWER ON/OFF button
pressed for one second.
3.2

Channel selection

The radios have 8 different transmission channels, which are released
by the European Committee for Radio Communications as " Private
Mobile Radio" channels, known as PMR for short.
In order to be able to speak between two radios, both units
must be set to the same channel.
Choose one of the 8 channels by pressing the MENU button once.
The message CHAN will flash in the display.
Now select the required channel between 1 and 8 using the
"
buttons. The display will show the channel that is currently
selected. Confirm the selection with the PUSH TO TALK button on the
left-hand side or wait for 10 seconds until the display returns to the
normal operating mode once more.
You can also make contact with other units that likewise make use of
the PMR channels and which are set to the same frequency. Please
refer to the technical data for more information.
- Operation -
!
and
43