JVC KD-T905BTS Manuel D'instructions page 21

BLUETOOTH®
The following operations may differ or be unavailable depending on the connected
phone.
To
First incoming call...
Answer a call
Reject a call
End a call
While talking on the first incoming call...
Answer another incoming
call and hold the current call
Reject another incoming call Press and hold
While having two active calls...
End current call and activate
held call
Swap between the current
call and held call
Adjust the phone volume*1
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes*3
*1 This adjustment will not affect the volume of the other sources.
*2 Press and hold VOL + to continuously increase the volume to 15.
*3 Operations may vary according to the connected Bluetooth device.
On the faceplate On the remote control
Press J / K / H / I.
Press or the volume
knob.
Press and hold
Press and hold or the
J / K / H / I.
volume knob.
Press and hold
Press and hold or the
J / K / H / I.
volume knob.
Press or the volume
( Not available )
knob.
or the
( Not available )
volume knob.
Press and hold
Press and hold or the
J / K / H / I.
volume knob.
Press .
( Not available )
Turn the volume knob Press VOL +*2 or
during a call. VOL – during a call.
Press during a call.
( Not available )
Improve the voice quality
While talking on the phone...
1 Press and hold .
2 Turn the volume knob to select an item (see the following
table), then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
[MIC GAIN] [LEVEL –10] to [LEVEL +10] ([LEVEL –04]): The sensitivity of
the microphone increases as the number increases.
[NR LEVEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the noise
reduction level until the least noise is being heard during a
phone conversation.
[ECHO CANCEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the echo
cancellation delay time until the least echo is being heard during
a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (page 18), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
To return to the previous setting item, press
.
Default: [XX]
.
17
ENGLISH