JVC KD-T905BTS Manuel D'instructions page 24

BLUETOOTH®
Bluetooth compatibility check mode
You can check the connectivity of the supported profile between the
Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
1
Press and hold .
"BLUETOOTH" "CHECK MODE" appears. "SEARCH NOW USING
PHONE" "PIN IS 0000" scrolls on the display.
2
Search and select the name of your receiver ("KD-T9
"KD-T8 BTS"/"KD-T7 BT"/"KD-TD9 BTS"/"KD-TD7 BT"/
"KD-SR8 BT") on the Bluetooth device within 3 minutes.
3 Perform (A), (B) or (C) depending on what appears on the display.
(A) "PAIRING" "XXXXXX" (6-digit passkey): Ensure that the same
passkey appears on the unit and Bluetooth device, then operate the
Bluetooth device to confirm the passkey.
(B) "PAIRING" "PIN IS 0000": Enter "0000" on the Bluetooth device.
(C) "PAIRING": Operate the Bluetooth device to confirm pairing.
After pairing is done successfully, "PAIRING OK"
and Bluetooth compatibility check starts.
If "CONNECT NOW USING PHONE" appears, operate the Bluetooth device to
allow phonebook access to continue.
"TESTING" flashes on the display.
20
ENGLISH
The connectivity result flashes on the display.
"PAIRING OK" and/or "HANDS-FREE OK"*1 and/or "AUD.STREAM OK"*2 and/
or "PBAP OK"*3: Compatible
*1 Compatible with Hands-Free Profile (HFP)
*2 Compatible with Advanced Audio Distribution Profile (A2DP)
*3 Compatible with Phonebook Access profile (PBAP)
After 30 seconds, "PAIRING DELETED" appears to indicate that pairing has
been deleted, and the unit exits check mode.
BTS"/
• To cancel, press and hold B SRC to turn off the power, then turn on the
"Device Name" appears
power again.