Cable Management; How To Use The Remote Control; Battery Installation And Replacement; Operating Range - Pioneer PDP-615EX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cable Management

Using the cable clamps provided with the plasma display,
bundle at the back of the unit the signal and audio cables
connected to the display.
Back of the unit
mounting holes
To attach
1.
clamp
mounting hole
To detach

How to use the remote control

Battery Installation and Replacement

Insert the 2 "AAA" batteries, making sure to set them in
with the proper polarity.
1.Press and open the cover.
2.Align the batteries according to the (+) and (–) indication
inside the case.
3.Replace the cover.
2.
cables

Operating Range

* Use the remote control within a distance of about 7 m/
23ft. from the front of the monitor's remote control sensor
and at horizontal and vertical angles of up to approximately
30°.
* The remote control operation may not function if the
monitor's remote control sensor is exposed to direct
sunlight or strong artificial light, or if there is an obstacle
between the sensor and the remote control.

Handling the remote control

• Do not drop or mishandle the remote control.
• Do not get the remote control wet. If the remote control
gets wet, wipe it dry immediately.
• Avoid heat and humidity.
• When not using the remote control for a long period,
remove the batteries.
• Do not use new and old batteries together, or use different
types together.
• Do not take apart the batteries, heat them, or throw them
into a fire.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country/area.
3
En

Publicité

Table des Matières
loading

Table des Matières