Zanussi ZCG053GW1 Notice D'utilisation page 19

The LPG conversion kit is available
from your Service Force Centre and must be
fitted by an authorised Service Engineer.
Replace the nozzles of the hob burners
Before any modifications or adapt the
range to a kind of different gas, ensure that
all control knobs are in the OFF position, and
the appliance has cooled completely.
Hob burners
•
Remove the pan supports;
•
Remove the caps and the burner crowns;
•
Using a No 7 socket spanner unscrew the
nozzles and replace them with those
required for the type of gas in use (see
table no. 1).
Reassemble the parts following the same
procedure in reverse.
These burners do not need any primary air
regulation.
Adjustment of minimum level for the hob
burners
The burner is correctly adjusted when the flame
is stable silent and goes out without any noise.
When changing the type of gas check that the
minimum level is correct. The air admission is
correct when the flame is about 4 mm in length.
The top burners do not need adjustment of
primary air.
Check that, turning the knob quickly from the
maximum position to the minimum one, the
flame does not go out.
Stick the label supplied with the
conversion kit (in the nozzles bag)
corresponding to the gas type utilized.
correct
no air
adjusting
excess
of air
19