Zanussi ZCG053GW1 Notice D'utilisation page 16

Advice for safety
Gas connections
•
Before installation ensure that the local
distribution conditions (gas type and
pressure) and the pre-setting of the
appliance are consistent.
•
This appliance must be installed only in a
room with good ventilation.
•
This appliance must not connected to a
chimney. It has to be installed and
connected in accordance with the rules in
force. Special attention should be paid to
the applicable disposal concerning
ventilation.
•
The adjacent furniture panels have to be
heat proof or protected by such material.
•
The adjusting conditions of this appliance
are mentioned on the rating plate.
Connection to gas supply.
Check that the gas flow and the diameter of the
supply pipe is sufficient to supply all the
appliances of the installation.
Gas connection must be carried out according to
the rules in force.
The manufacturing company release the unit,
once tested, adjusted for the kind of gas stated
on the adjustment label located on the back of
the range, next to connection pipe. Be sure that
you are going to connect the unit to the same
kind of gas written on the plate. Otherwise,
follow all the instructions of the paragraph
"Change of gas".
For best efficiency and lowest consumption, be
sure that manifolds gas pressure respects the
values in the table of "Specification nozzles".
16
Connection using a rigid pipe or a
flexible metal pipe
To ensure higher safety, it is recommended
to carry out the connection to the gas
system using rigid pipes (ex. copper) or
using flexible stainless steel pipes, to avoid
any stress to the unit.
Gas feeding pipe fitting is Gc 1/2.
For this type of installation, connection to
the gas supply should be carried out using
only and exclusively flexible metallic tubes
in conformity with rules in force.
Connection using flexible, non metal
pipes
When the connection can be easily
inspected in its full extent, there is the
chance to use a flexible pipe according to
the rules in force.
The flexible pipe should be made ready for
use in such a way that:
- nowhere it can reach over temperature,
other than room temperature, higher than
30°C; if the flexible pipe, to reach the cock,
must run behind the range, it must be
installed as shown.
- it is no longer than 1500 mm;
- it shows no throttles;
- it is not subject to traction or torsion;
- it doesn't get in touch with cutting edges or
corners;
- it can be easily inspected in order to check
its condition.