Infant Child Restraint Installation - Joie gemm Manuel D'utilisateur

i. Pull the crotch harness out
and place it to be level.
-1& -2& -3
17 17 17
ii. Rotate the crotch harness
anchor to make the short
side forwards, then thread it
through the crotch harness
slot. -4
17
iii. Rethread it through the slot
that is closest to child's
crotch from the front of the
crotch harness.
16
4. Place child into the infant child
restraint and lock the buckle.
&
18 19
13
17
1 2 3 4
18
19
5. Tighten the shoulder harnesses
by pulling adjustment
webbing.
20
!
Make sure the space
between the child and the
shoulder harnesses is about
the thickness of one hand.
Infant Child Restraint
Installation
see images -
21 32
The installation instructions vary
depending on whether or not you
are using the base. Please refer
to the proper section.
!
Do not place the infant child
restraint on front vehicle seat
with airbag. Death or serious
injury can occur.
21
!
When using the infant child
restraint in a vehicle seat,
please adjust the handle to
position 1. -1
5
!
Face your child restraint or base
toward the rear of the vehicle.
!
Ensure the vehicle safety belt is
not loose or twisted.
20
21
14