Installing With Base - Joie gemm Manuel D'utilisateur

i. Installing without
Base
see images -
22 25
After fitting the harness to your
child and determining which rear
vehicle seat location is best, you
are ready to install your infant
child restraint.
1.Place the infant child restraint
onto the vehicle seat where
you wish to put it. Pull the
vehicle safety belt out and lock
it into the vehicle buckle,
sliding the vehicle lap belt into
the side guides of the infant
child restraint.
22
!
The child restraint can
not be used if the vehicle
safety belt buckle (female
buckle end) is too long to
anchor the child restraint
securely. -1
22
2. Slide diagonal belt into the rear
guide.
23
3. Pull the belt to fasten the infant
child restraint tightly and
securely.
24
!
Tension the vehicle safety
belt as much as possible,
check that it is not loose or
twisted.
!
The vehicle safety belt shall
not cause pressure on any
part of the child.
15
22
!
!
1
23
!
24
Correctly assembled vehicle
safety belt is shown as .
25
!
Lap belt must pass through
the two side guides,
as -1.
25
!
The vehicle buckle is locked
correctly, as -2.
25
!
Diagonal belt must pass
through the rear guide,
as -3.
25
ii. Installing with Base
see images -
26 32
1. Unfold the load leg from
storage compartment.
26
2. After placing the base on the
vehicle seat, squeeze load leg
adjustment button to extend
the load leg to floor -1,
27
the load leg indicator shows
green means it is installed
correctly, red means it is
installed incorrectly. -2
27
!
The load leg has 8 positions.
When the load leg indicator
shows red this means the
load leg is in the wrong
position.
!
Make sure the load leg is
secure by pressing down on
the front of the base.
25
1
3
2
26
27
1
2
16