Securing Child - Joie i-Spin 360 Mode D'emploi

Securing Child

1. Press the webbing adjustment
button, while pulling out the
shoulder harnesses to the desired
(Pull from below the fixed
shoulder pads to lengthen) length.
27
2. Unlock the buckle of the
harnesses by pressing the red
button.
28
3. Fix the buckles on the both sides
of the seat shown as which
29
located on the both sides of seat
to make placing the child in rear
facing mode more convenient.
4. Please make sure the infant insert
has the wedge assembled before
using it for infant.
30
19
27
28
29
30
Detach the snaps on
the head support to
remove the head
portion of the infant
insert.
We recommend using the full
infant insert while the baby is
under 60cm and can be used
until they outgrow the infant
insert. The infant insert
increases side impact
protection.
5. Place the child into the enhanced child restraint and pass both arms
through the harnesses.
!
After the child is seated, recheck whether the shoulder harnesses
are at the proper height.
6. Engage the buckle. Please refer to
31
Remove the head
support portion of the
infant insert when the
child's head no longer fits
comfortably.
Remove the body portion
of the infant insert when
the infant's shoulders no
longer fit comfortably.
Remove the infant insert
1
cushion by detaching the
snaps to allow more
space when the infant
does not fit comfortably.
The cushion can be used
separately without being
2
attached to the infant
insert to bolster the
infant's back for more
comfort.
31
20