LORCH M-Pro BasicPlus Manuel D'utilisation page 47

Messages
Code Error description
E01 Excessive tempe-
rature
E02 Mains overvoltage
E03 Overcurrent
E06 Overvoltage
E07 EEProm checksum
error
E08 Wire feed
E09 Voltage-measuring
E13 Temp. sensor error
E14 Supply voltage
E15 Power measuring
E16 Supply voltage
motor and main
contactor
E17 Peripherie overload/
short circuit
E18 Error configuration
Tab. 8: Messages
01.10
Note
The equipment has been overhea-
ted
Mains input voltage too high
Output current is too high / Perma-
nent short circuit
Output voltage too high
Setting data faulty or missing
Too high power intake from wire
feed motor (Motor Over-Current)
Voltage measuring system defective Service verständigen
Thermal sensor not ready for ope-
ration
internal supply voltage too low
(18V~ / 24V-)
Fault at power measuring
Internal supply voltage is too little
(42V~ / 60V-)
Short circuit in torch or hose packa-
ge, gas valve or feed line, wire run
key or line
Faulty or wrong pc-board,
wrong software system played
Rectification
Allow the system to cool
down in standby, check
the ventilation system
Check mains voltage
Service verständigen
Inform Service
Switch the equipment
off and on again
Blow down torch pac-
kage with pressured air
and check pressure on
wire feed rolls.
Inform Service
Check mains voltages
Service verständigen
Check power supply
voltage
Test alt. exchange the
connected torch
Inform Service
- 47 -