General Regulation Of Use; Unit Protection; Noise Emission - LORCH M-Pro BasicPlus Manuel D'utilisation

Keep a fire extinguisher near the
welding area.
Check the welding area for fire af-
ter welding (see UVV*).
Never try to disassemble the pres-
sure reducer. Replace the defecti-
ve one.
The machine must be transported
or set up only on firm, level surfaces.
The maximum admissible angle of
inclination for setting up or trans-
porting is 10°.
Service and repair work may only be ca-
‰
rried out by a trained electrician.
Ensure that the ground cable has good
‰
and direct contact near the welding loca-
tion. Do not allow welding current to pass
through chains, ball bearings, steel cables
or grounding equipment; this may melt
them.
Secure yourself and the welding machine
‰
when working in elevated or inclined areas.
The machine may only be connected to a
‰
properly grounded mains supply. (Three-
phase four-wire system with grounded
neutral conductor or single phase-three-
wire system with grounded neutral con-
ductor) socket and extension cable must
have a functional protective conductor.
Wear correct protective clothing, leather
‰
gloves and leather apron.
Protect the welding area with curtains or
‰
mobile screens.
Do not use this machine to thaw frozen
‰
water pipes or cables.
In closed containers, under cramped con-
‰
ditions, and in high electrical risk areas,
only use machines with the S sign.
Switch off the machine during breaks and
‰
close the valve of the gas cylinder.
Secure the gas cylinder with a chain to
‰
prevent it falling over.
- 32 -
Disconnect the mains plug from the mains
‰
before changing the place of installation
or making repairs to the machine.
Please heed the safety regulations which
apply to your country. Subject to change.
4

General regulation of use

This unit is for welding of steel, aluminium
and their alloys as well as for brazing with
CuSi wires for commercial as well as for in-
dustrial use.
5

Unit protection

This machine is protected electronically
against overloading. Do not use fuses of
higher amperage than printed on the iden-
tification plate.
Close the side cover before starting any wel-
ding work.
6

Noise emission

The noise level of the unit is less than 70
dB(A), measured under standard load in ac-
cordance with EN 60974-1 in the maximum
working point.
Noise emission
01.10