LORCH M-Pro BasicPlus Manuel D'utilisation page 44

13 .4 Characeristic connection
The characteristic selection knob 65 and
‰
the corresponding table are in the wire
feed casing.
Abb. 17: Characteristic table
The table content may differ from
i
your welding machine. The cha-
racteristic lines are set individually
for each machine type.
Select the required material-wire-gas
Â
combination from the characteristic table.
Read the corresponding characteristic
Â
number off from the right hand column.
- 44 -
65
Abb. 18: Characteristic selection knob
Set the corresponding number from the
Â
table using selection knob 65.
Below the characteristic number 0 (ma-
‰
nual mode)
– is the material-wire-gas combination
nullified. Wire feed and welding volta-
ge can be set manually.
– the welding step (Basic Plus) instead
of material thickness will be displa-
yed.
– the must-value for welding voltage
(Control Pro) instead of material thic-
kness will be displayed.
If an unassigned number is set with
i
the characteristic selection knob
65, the 7-segment-display 47 will
display the error message „noP".
Start-up
01.10