Charging With The Supply Unit; Charging In The Smartclean System (Specific Types Only) - Philips 6000 Série Mode D'emploi

Quick charge

Charging with the supply unit

Charging in the SmartClean system (specific types
only)
1
2
After approx. 3 minutes of charging, the shaver
contains enough power for one shave. The bottom
light of the battery charge indicator starts flashing
white slowly when the quick charge is finished.
1 Make sure the shaver is switched off.
2 Put the small plug in the shaver and put the
supply unit in the wall socket.
The display of the shaver indicates that the
shaver is charging.
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
shaver.
1 Put the small plug in the back of the
SmartClean system.
2 Put the supply unit in the wall socket.
3 Press to open the SmartClean system cap, to be
able to place the shaver in the holder ('click').
4 Hold the shaver upside down above the holder.
Make sure the front of the shaver points
towards the SmartClean system holder.
13
English