Philips 6000 Série Mode D'emploi page 28

28
English
7 Put the cutter back into the guard.
8 Place the shaving heads in the shaving head
holder.
Note: Make sure that the projections of the
shaving heads fit exactly into the recesses of
the shaving head holder.
9 Place the retaining rings back onto the shaving
head holder and turn them clockwise ('click').
Note: Hold the shaving head holder in your
hand when you reinsert the shaving heads and
reattach the retaining rings. Do not place the
shaving head holder on a surface when you do
this, as this may cause damage.
- Each retaining ring has two recesses and two
projections that fit exactly in the projections
and recesses of the shaving head holder.