Thorough Cleaning - Philips 6000 Série Mode D'emploi

26
English

Thorough cleaning

4 Press the on/off button on the SmartClean
system to start the cleaning program.
During the cleaning phase, the cleaning symbol
flashes. When the cleaning phase is done (after
approx. 10 minutes), the cleaning symbol lights
up continuously.
Next, the ready symbol lights up continuously.
30 minutes after the cleaning program and
charging are done, the SmartClean system
switches off automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged.
Charging takes approx. 1 hour.
5 To let the shaver dry, you can leave it in the
SmartClean system until your next shave. You
can also remove the shaver from the
SmartClean system, shake off excess fluid, open
the shaving unit and let the shaver air-dry.
Press to open the SmartClean cap, to remove
the shaver from the holder ('click').
Note: Note: If you press the on/off button of the
SmartClean system during the cleaning program,
the program stops. In this case, the cleaning or
drying symbol goes out.
Note: Note: If you disconnect the SmartClean
system from its power supply, the cleaning
program stops.
1 Switch off the appliance.