Philips 6000 Série Mode D'emploi page 25

1
3
2
6 While holding the SmartClean system with one
hand, gently push the top part of the
SmartClean system back down ('click').
Using the SmartClean system
Note: If you use the shaver with shaving foam,
shaving gel or pre-shave products, briefly rinse the
shaver with warm water before you clean it in the
SmartClean system.
Caution: Always shake excess water off the
shaver before you place it in the SmartClean
system.
1 Press to open the SmartClean system cap, to be
able to place the shaver in the holder ('click').
2 Hold the shaver upside down above the holder.
Make sure the front of the shaver points
towards the SmartClean system holder.
3 Place the shaver in the holder, tilt the shaver
backwards and press down the SmartClean
system cap to connect the shaver ('click').
The battery symbol on the SmartClean system
starts to flash, which indicates that the shaver is
charging.
25
English