Using The Shaver - Philips 6000 Série Mode D'emploi

14
English
1
3
2

Using the shaver

Switching the shaver on and off
5 Place the shaver in the holder, tilt the shaver
backwards and press down the SmartClean
system cap to connect the shaver ('click').
The battery symbol flashes to indicate that the
appliance is charging. When the battery is fully
charged, the battery symbol lights up
continuously.
Always check the shaver and all accessories
before use. Do not use the shaver or any
accessory if it is damaged, as this may cause
injury. Always replace a damaged part with one of
the original type.
- Use this shaver for its intended household use
as described in this manual.
- For hygienic reasons, the shaver should only be
used by one person.
- Trimming is easier when the skin and hair are
dry.
- Do not place the SmartClean system near water
and make sure it does not get wet.
Note: This shaver is waterproof. It is suitable for
use in the bath or shower and for cleaning under
the tap. For safety reasons, the shaver can only be
used without cord.
1 To switch the shaver on or off, press the on/off
button once.
The display lights up for a few seconds to show
the battery status.