Using The Shaver - Philips 6000 Série Mode D'emploi

Using the shaver

Switching the shaver on and off
3 Place the shaver in the charging stand.
4 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
charging stand.
Always check the shaver and all accessories
before use. Do not use the shaver or any
accessory if it is damaged, as this may cause
injury. Always replace a damaged part with one of
the original type.
- Use this shaver for its intended household use
as described in this manual.
- For hygienic reasons, the shaver should only be
used by one person.
- Trimming is easier when the skin and hair are
dry.
- Do not place the SmartClean near water and
make sure it does not get wet.
Note: This shaver is waterproof. It is suitable for
use in the bath or shower and for cleaning under
the tap. For safety reasons, the shaver can only be
used without cord.
1 To switch the shaver on or off, press the on/off
button once.
The display lights up for a few seconds to show
the battery status.
13
English