Philips 6000 Série Mode D'emploi page 21

1 Pull the comb off the beard styler attachment.
2 Rinse cut hairs off the cutting unit with
3 Rinse cut hairs off the comb.
4 Remove the cutting unit from the beard styler
5 Rinse cut hairs out of the beard styler
6 Carefully shake off excess water and let the
7 When the cutting unit is dry, attach it to the
2
1
Note: Grab the comb in the center to pull it off
the beard styler attachment. Do not pull at the
sides of the comb.
lukewarm water.
attachment. By pushing the cutting unit off the
beard styler attachment, you can remove any
hairs that have accumulated inside the beard
styler. You can also rinse the bottom of the
cutting unit.
attachment.
comb, cutting unit and beard styler attachment
air-dry before you use them again.
beard styler attachment.
21
English