Charging With The Supply Unit - Philips S3000 Série Mode D'emploi

Charging with the supply unit

Charging with charging stand (S3332, S3333 only)
Charging takes approx. 1 hour. A fully charged
shaver has a shaving time of up to 60 minutes.
This shaver is suitable for use in the bath or
shower. For safety reasons, it is therefore
not possible to use the shaver while it is
connected to the power outlet for charging.
Note: Depending on your shaving/styling behavior
and beard type, the operating time may vary over
time.
1 Put the small plug in the appliance.
2 Put the supply unit in the wall socket.
- The charging light shows the charging status of
the appliance.
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
1 Connect the small plug of the cord into the
charging stand. Connect the supply unit into
any 100V to 240V outlet. Use only the power
cord provided.
2 Place the shaver in the stand in an upright
position making sure charging contacts in the
bottom of stand fit into recess in bottom of the
shaver.
- The display on the shaver will indicate the
shaver is charging.
3 After charging, remove the shaver from the
stand by lifting straight up. Do not tilt the
shaver.
11
English