Replacing Shaving Heads; Charging With The Supply Unit; Using The Shaver - Philips Star Wars SW5700/07 Mode D'emploi

Replacing shaving heads

Charging

Charging with the supply unit

Using the shaver

For maximum shaving performance, replace the
shaving heads every two years. The shaver is
equipped with a replacement reminder which
reminds you to replace the shaving heads. The
replacement reminder flashes to indicate that you
have to replace the shaving heads (see 'Replacing
the shaving heads').
Note: After replacing the shaving heads, you need
to reset the replacement reminder by pressing the
on/off button for 7 seconds.
Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty.
Charging takes approx. 1 hour. A fully charged
shaver has a shaving time of up to 50 minutes.
Note: You cannot use the shaver while it is
charging.
1 Make sure the shaver is switched off.
2 Put the small plug in the shaver and put the
supply unit in the wall socket.
The display of the shaver indicates that the
shaver is charging.
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
shaver.
Always check the shaver and all accessories
before use. Do not use the shaver or any
accessory if it is damaged, as this may cause
13
English