Typical Applications; Installation; Wiring Diagram; Initial Configuration - Vortice LINEO 250 QUIET ES Notice D'emploi Et D'entretien

ENGLISH

Typical applications

LINEO 250 QUIET ES / LINEO 315 QUIET ES: fig. 1-2

Installation

Fig. 3 ÷ 26.
Fig.3: B=Inlet; C= Outlet.

Wiring diagram

LINEO 250 QUIET ES: Fig. 17 ÷ 21 LINEO 315 QUIET ES: Fig. 22 ÷ 26.

Initial configuration

The installer must configure appliance operation by following the steps described later on.
Selecting the product model: see below. This step is carried out in the factory; the instructions provided in this
booklet may only be of use if it becomes necessary to reset the status following accidental tampering with the
dip-switch.
Selecting the operating mode: see below. There are two modes: with two speeds V1 and V2, which can be
selected via an external switch, or with speed that can be adjusted via an external potentiometer.
Setting the V1 and V2 values (for two-speed operating mode)
Selecting the product model
The model is selected by setting the dip-switch 1 indicated in the figure as described in the table below.
DIPSWITCH
ON
SW 1 : MODEL
OFF
SW 2 : SETUP
2 1
TRIMMER
LINEO 250 QUIET ES
LINEO 315 QUIET ES
1 2 3 4
Model
LINEO 250 QUIET ES
LINEO 315 QUIET ES
SW1
Int. 1 Int. 2 Int. 3
OFF ON ON
OFF ON ON
Int. 4
OFF
ON
13