Call History - Kenwood DPX791BH Mode D'emploi

BLUETOOTH®
Make the settings for receiving a
call
1
Press to enter
Bluetooth mode.
2
Turn the volume knob to make a
selection (see the following table), then
press the knob.
3 2
Repeat step until the desired item is
selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
.
SETTINGS
AUTO ANSWER 1 — 30: The unit answers incoming
call automatically in the selected
time (in seconds). ; OFF: Cancels.
BATT/SIGNAL AUTO: Shows the strength of the
battery and signal when the unit
detects a Bluetooth device and the
Bluetooth device is connected. ;
OFF: Cancels. Clock time is shown.
Make a call
Default: XX
You can make a call from the call history, phonebook, or dialing the number. Call by voice is also
possible if your mobile phone has the feature.
1
Press
2
Turn the volume knob to make a selection (see the following table), then press the knob.
3 2
Repeat step
the selected item.
4
Press and hold
To return to the previous setting item, press

CALL HISTORY

to enter Bluetooth mode.
until the desired item is selected/activated or follow the instructions stated on
to exit.
1 Press the volume knob to select a name or a phone number.
• "INCOMING", "OUTGOING", or "MISSED" is shown on the lower part of the display to indicate the
previous call status.
• Press to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
.
17
ENGLISH