Kenwood DPX791BH Mode D'emploi page 18

BLUETOOTH®
BLUETOOTH — Mobile phone
Receive a call
When there is an incoming call:
– All the buttons flash.
– The unit answers the call automatically if [AUTO ANSWER] is set to a selected time. ( 17)
During a call:
– The buttons and display illuminate according to the settings made for [DISPLAY]. ( 23)
– If you turn off the unit, the Bluetooth connection is disconnected.
To On the faceplate
Answer a call
Press
number buttons (1 to 6).
Reject a call
Press
End a call
Press
Adjust the phone volume Turn the volume knob during a call.
[00] to [35] (Default: [15]*) • This adjustment will not affect the
Switch between hands- Press 6 during a call.
free and private talk • Operations may vary according to
modes
* Not applicable for iPhone. During a call, the unit synchronizes the phone volume on the iPhone to the unit.
16
or one of the
.
or .
volume of the other sources.
the connected Bluetooth device.
While talking on the phone...
1
2
3
4
To return to the previous setting item, press
MIC GAIN
NR LEVEL
ECHO CANCEL
On the remote control
Press .
Press .
Press .
—
—
Improve the voice quality
Press FNC to enter [FUNCTION].
Turn the volume knob to make a selection
(see the following table), then press the knob.
2
Repeat step until the desired item is
selected or activated.
Press and hold to exit.
–10 — +10 (–4): The sensitivity of
the microphone increases as the number
increased.
–5 — +5 (0): Adjust the noise reduction
level until the least noise is being heard
during a phone conversation.
–5 — +5 (0): Adjust the echo cancellation
delay time until the least echo is being heard
during a phone conversation.
.
Default: XX