Kenwood DPX791BH Mode D'emploi page 21

BLUETOOTH®
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number
buttons (1 to 6).
1 Press to enter Bluetooth
mode.
2
Turn the volume knob to select [CALL HISTORY],
[PHONE BOOK], or [NUMBER DIAL], then press the
knob.
3
Turn the volume knob to select a contact or
enter a phone number.
If a contact is selected, press the volume knob
to show the phone number.
4
Press and hold one of the number buttons (1
to 6).
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select
2
[NUMBER DIAL] in step and store a blank number.
Make a call from memory
1
Press to enter Bluetooth
mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO MEMORY" appears if there is no contacts
stored.
Other settings
1 Press FNC to enter [FUNCTION].
2 Turn the volume knob to make a selection (see the following table), then press the knob.
3 2
Repeat step until the desired item is selected/activated or follow the instructions stated
on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
BT MODE
PHONE SELECT Selects the phone or audio device to connect or disconnect.
" * " appears in front of the device name when connected.
• You can only connect another Bluetooth device by disconnecting the connected Bluetooth device
AUDIO SELECT
first.
" * " disappears when disconnected.
1 Turn the volume knob to select a device to delete, then press the knob.
DEVICE DELETE
2 Turn the volume knob to select [YES] or [NO], then press the knob.
PIN CODE EDIT Changes the PIN code (up to 6 digits).
1 Turn the volume knob to select a number.
(0000)
2 Press S / T to move the entry position.
Repeat steps
3 Press the volume knob to confirm.
RECONNECT ON: The unit automatically reconnect when the last connected Bluetooth device is within range. ;
OFF: Cancels.
AUTO PAIRING ON: The unit automatically pair supported Bluetooth device (iPhone/ iPod touch/ Android device)
when it is connected through USB input terminal. Depending on the operating system of the
connected device, this function may not work. ; OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing, phonebook, and etc.). ;
NO: Cancels.
.
1 2
and until you finish entering the PIN code.
Default: XX
19
ENGLISH