Connecting Antennas - JVC RX-D212B Manuel D'instructions

Connecting antennas

Do not connect the AC power plug to the wall outlet until all connections are completed.
7 Connecting FM and AM antennas
If FM reception is poor,
connect an outdoor FM
antenna (not supplied).
FM antenna (supplied)
AM antenna connection
Connect the AM loop antenna supplied to the AM LOOP terminals.
Connect the white cord to the AM EXT terminal, and connect the
black cord to the H terminal.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-covered
wire (not supplied) to the AM EXT terminal. Keep the AM loop
antenna connected.
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL
terminal as a temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable with a
connector, disconnect the supplied FM antenna.
7 Connecting the XM Connect and Play Digital Antenna
To enjoy XM Satellite Radio, connect the XM Connect and Play Digital Antenna (not supplied) to the XM jack.
NOTE
For the best reception:
– Place the XM Connect and Play Digital Antenna near a south-facing window or where "Channel 1" can be heard clearly (see page 17).
– Make sure there is no obstruction between the XM Connect and Play Digital Antenna and the sky.
Snap the tabs on the
loop into the slots of
the base to assemble
the AM loop antenna.
ANTENNA
AM LOOP
FM 75
COAXIAL
AM EXT
NOTES
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl while twisting it as shown on the
right.
• Make sure the antenna conductors do not touch
any other terminals, connecting cords and power
cord. This could cause poor reception.
AM loop antenna
(supplied)
If AM reception is poor, connect
an outdoor single vinyl-covered
wire (not supplied).
XM Connect and Play Digital
Antenna (not supplied)
5