Operating Other Jvc Products - Jvc Rx-D212B Manuel D'instructions

Operating other
JVC products
You can use the supplied remote control to operate not only
this receiver but also other JVC products.
• Refer also to the manuals supplied with the other products.
– Some JVC VCRs can accept two types of control signals—
remote codes "A" and "B." This remote control can operate a
VCR whose remote control code is set to "A."
– Some JVC DVD recorders can accept four types of control
signals. This remote control can operate a DVD recorder
whose remote control code is set to the initial code. For
details, refer to the manual supplied with the DVD recorder.
• To operate other products, aim the remote control directly at the
remote sensor on the target product.
7 TV
1
4
7
10
You can always perform the following operations:
TV/SIRIUS : Turn on or off the TV.
TV VOL +/–: Adjust the volume on the TV.
TV/VIDEO: Change the input mode (either video
input or TV tuner) on the TV.
After pressing TV, you can perform the following operations on the
TV.
CHANNEL +/–: Change the channel numbers.
1 – 9, 0, 100+ (h10): Select the channel numbers.
RETURN (10): Switch between the previous channel
and the current channel.
2 3
5 6
8 9
0 10
7 VCR
1 2 3
5 6
4
7 8 9
10
0 10
You can always perform the following operation:
VCR : Turn on or off the VCR.
After pressing VCR, you can perform the following operations on
the VCR.
CHANNEL +/–: Change the channel numbers on the VCR.
1 – 9, 0: Select the channel numbers on the VCR.
3:
Start playback.
7:
Stop playback.
8: Pause playback. To release it, press 3.
¡:
Fast-wind a tape.
1:
Rewind a tape.
After pressing SIRIUS, you can perform the following operations
on the SIRIUS Satellite Radio.
TV/SIRIUS : Turn on or off the SIRIUS Satellite Radio.
CHANNEL +/–: Change the channel numbers on the SIRIUS
Satellite Radio.
SELECT: Select a highlighted item on the display of the
SIRIUS Satellite Radio.
CAT 9/( CAT: Change the category of the program.
MENU: Enter and exit from the Menu Option screen of
the SURIUS Satellite Radio.
DISPLAY: Change the text size on the display of the
SIRIUS Satellite Radio.
1 – 9, 0, BAND: Store or tune in to the preset channel.
MEMORY: Store information on the display of the SIRIUS
Satellite Radio.
DIRECT: Enable access to channels of the SIRIUS
Satellite Radio directly by numeric buttons.
PREV: Return to the previous channel.
NOTE
The remote control may not operate properly for a SIRIUS
Satellite Radio other than KT-SR2000 (JVC SIRIUS Satellite
Radio).
7 SIRIUS Satellite Radio
1 2 3
5 6
4
7 8 9
10
0 10
37