Maintenance - Renkforce AN-8015BT Mode D'emploi

Maintenance

Check the technical safety of the car radio regularly, e.g. for damage to the connection cables or to the casing.
If it can be assumed that safe operation is no longer possible, the device must be turned off and precautions are to
be taken to ensure that it is not used unintentionally. Disconnect the car power system!
It can be assumed that safe operation is no longer possible if:
• the device is visibly damaged
• if the device does not function for some reason, or
• following considerable stress during transportation
Always observe the following safety information before cleaning or servicing the car radio:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work
is carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must
perform repairs.
If it becomes necessary to replace a fuse, make sure that only fuses of the prescribed type and nominal current are
used (see "Technical Data").
Never repair fuses or bridge the fuse holder.
• When the power supply has been disconnected (disconnect cable tree plug!) carefully remove the fuse from the
fuse holder next to the cable tree connection.
• Replace it with a fuse of the same type.
• After this, you can reconnect the car radio to the board mains and take it into operation.
• Should the fuse trigger again, have the CD tuner repaired in a specialised workshop.
Apart from this, the device does not need any servicing. The device's outside should be cleaned with a soft, dry cloth
or a brush only.
Never use any aggressive cleaning agents or chemical solutions that may damage the surface of the casing.
81