Connection Of The Speakers And The Power Supply - Renkforce AN-8015BT Mode D'emploi

Connection of the Speakers and the Power Supply

The car radio has an ISO system plug.
Vehicles equipped with such a system plug can be connected directly to the system if the plug assignment is the same
(please check beforehand!). In case of deviating plug assignment, connection takes place via an adapter.
Please refer to the following table for the contact assignment of the ISO system socket. Please ask your car dealer
for the respective assignment of your vehicle system plug.
System plug A (power supply)
(1) (Not assigned)
(2) (Not assigned)
(3) (Not assigned)
(4) Continuous current +12V
(5) Aerial control output
(6) (Not assigned)
(7) Ignition +12V
(8) Ground
58
System connector B (speaker connection)
(1) Speaker rear right (+)
(2) Speaker rear right (-)
(3) Speaker front right (+)
(4) Speaker front right (-)
(5) Speaker front left (+)
(6) Speaker front left (-)
(7) Speaker rear left (+)
(8) Speaker rear left (-)
Operating Instructions

English