Renkforce AN-8015BT Mode D'emploi page 64

TA SEEK/ALARM
TA SEEK When the radio has lost the traffic information, it will seek a new station with Traffic Announcement
coding on its own.
TA ALARM When the radio cannot receive the TA code anymore, there will be an alarm signal.
PI SOUND/MUTE
Device reaction when a transmission area is reached where 2 different stations with different programme
identification (PI) are transmitting the same alternative frequency (AF):
PI SOUND The radio switches to the new station for a few seconds and then back.
PI MUTE The new station is muted.
RETUNE L/S
RETUNE L When the radio does not receive traffic announcements any more, the auto-scan starts 90 seconds
later.
RETUNE S When the radio does not receive traffic announcements any more, the auto-scan starts 30 seconds
later.
MASK DPI/ALL
Device reaction during channel search:
MASK DPI Alternative frequencies with different programme information (PI) are not considered.
MASK ALL Alternative frequencies with different programme information (PI) and alternative frequencies with
high signal strength but without RDS information are not considered.
TAVOL
In case of traffic reports and activated TA function, the pre-set volume is selected where the volume set is lower.
Set the desired volume by turning the volume controller/selection controller (2).
CLOCK 12/24
Set the desired time format in this menu item (12h or 24h format).
Button confirmation sound BEEP
BEEP ON A confirmation sound sounds when a button is pushed.
BEEP OFF The confirmation sound is switched off.
64
Operating Instructions

English