Installer Setting - Zone Type Setting - Friedrich DWC1 Manuel D'installation Et D'utilisation

Installer Setting - Zone Type Setting

This function is only available on some products.
It is possible to setup zone new type or old one of the product which is available to install the damper
controller.
CAUTION
If you set zone number incorrectly, the product may malfunction especially in zone control.
This function must carried out by a certificated-technician.
If pressing button long for 3
1
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it
enters into user setup mode.
Please press more than 3 seconds for
sure.
Repeat pressing
2
Function code 13.
Function Code
Ex) Setting the Zone Type as "New"
Select Zone Type by pressing
3
button
(00:Old, 01:New)
Press button to save or release.
4
Press button to exit or
5
system will automatically exit
after 25 seconds without any
input.
Owner's & Installation Manual 19
Installation instruction
button to select
Zone type value