Installer Setting - Static Pressure Setting - Friedrich DWC1 Manuel D'installation Et D'utilisation

Installer Setting - Static Pressure Setting

This function is applied to only duct type. Setting this in other cases will cause malfunction.
<Static Pressure Setting Table>
Pressure selection
01 V-H
02 F-H
03 V-L
04 F-L
Press button for 4 seconds
1
to enter the installer setting
mode until timer segment
displays "01:01".
If pressing
2
moves to static pressure selection menu
as picture below.
Select static pressure by pressing
3
button.
(01:V-H, 02:F-H, 03:V-L, 04:F-L)
Function Code Pressure
Press button to save.
4
5
Pressing button will exit settings mode.
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
Function
Zone state
Variable
Fixed
Variable
Fixed
Owner's & Installation Manual 15
Installation instruction
button repeatedly, it
ESP standard value
High
High
Low
Low