Installer Setting - Test Run Mode - Friedrich DWC1 Manuel D'installation Et D'utilisation

Installation instruction

Installer Setting - Test Run Mode

After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
10 DWC1 Programmable Thermostat
Long press
1
enters into remote controller setting
mode.
- Press button with a short press,
controller enters user set up mode. To
ensure set up mode user may need to
press button for 3 seconds.
Function Code
Setup figure '01' blinks at the lower part
2
of indication window.
Press button to start.
3
During the test run, pressing the below
4
button will exit the test run.
- Select operation, temperature
up/down, wind flow control, wind
direction, start/stop button.
button for 3 seconds, it
Set