Installer Setting - Ceiling Height Selection - Friedrich DWC1 Manuel D'installation Et D'utilisation

Installation instruction

Installer Setting - Ceiling Height Selection

This function is to adjust FAN Airflow rate according to ceiling height (For ceiling type product)
<Ceiling Height Selection Table>
Ceiling Height Level
01 Low
02 Medium
03 High
04 Very high
•
Ceiling height setting is available only for some products.
•
Ceiling height of 'Very high' function may not exist depending on the indoor unit.
•
Refer to the product manual for more details.
14 DWC1 Programmable Thermostat
If pressing
1
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
If moving to ceiling height selection menu by
2
pressing
below.
Select ceiling height value by pressing
3
03:High, 04:Very high)
Function Code
Press
4
Pressing
5
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
Decrease the indoor airflow rate 1 step from standard level
Set the indoor airflow rate as standard level
Increase indoor airflow rate 1 step from standard level
Increase indoor airflow rate 2 steps from standard level
button long for 3
button, it indicates as picture
button. (01:Low, 02:Medium,
Thermistor setting
button to save.
button will exit settings mode.
Description