Installer Setting - Zone State - Friedrich DWC1 Manuel D'installation Et D'utilisation

Installer Setting - Zone State

It is the function to setup indoor unit's wind flow to variable or fixed.
- Variable : Comp ON, setup airflow. Comp OFF, weak wind
- Fixed : Comp ON, setup airflow. Comp OFF, setup airflow
If pressing button long for 3
1
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
If moving to ceiling height selection menu by
2
pressing button, it indicates as picture
below.
Select Zone State rate fixing mode by
3
pressing
(01: Variable, 02: Fixed)
Function Code Zone State
fixing mode
Press button to save.
4
5
Pressing button will exit settings mode.
❈ After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
Owner's & Installation Manual 17
Installation instruction
button.