CapsoVision CapsoAccess Instructions D'utilisation page 13

Table 2 — Guidance and manufacturer' s declaration – electromagnetic immunity
The CapsoAccess® system is intended for use in the electromagnetic environment specified below.
The customer or the user of the CapsoAccess® system should assure that it is used in such an environment.
Immunity test IEC 60601 test level
Electrostatic discharge ± 8 kV contact
(ESD) IEC 61000-4-2 ± 15 kV air
Electrical fast transient/ ± 2 kV for power supply lines
burst IEC 61000-4-4 ± 1 kV for input/output lines
Surge ± 1 kV line(s) to line(s)
IEC 61000-4-5 ± 2 kV line(s) to earth
Voltage dips:
0% UT; 0.5 cycle
Voltage dips, short
At 0°, 45°, 90°, 135°, 180°, 225°, 270°
interruptions and
and 315°
voltage variations on
0% UT; 1 cycle and 70% UT; 25/30 cycles
power supply input
Single phase: at 0°
lines IEC 61000-4-11
Voltage interruptions:
0% UT; 250/300 cycles
Power frequency
(50/60 Hz)
30 A/m
magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
12
Compliance level
± 8 kV contact
± 15 kV air
± 2 kV for power supply lines
± 1 kV for input/output lines
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
Voltage dips:
0% UT; 0.5 cycle
At 0°, 45°, 90°, 135°, 180°, 225°, 270°
and 315°
0% UT; 1 cycle and 70% UT; 25/30 cycles
Single phase: at 0°
Voltage interruptions:
0% UT; 250/300 cycles
30 A/m
IFU-2800 Rev E 11/18
Electromagnetic environment –
guidance
Floors should be wood, concrete or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30%.
Mains power quality should be that of a
typical commercial or hospital
environment.
Mains power quality should be that of a
typical commercial or hospital
environment.
Mains power quality should be that of a
typical commercial or hospital
environment. lf the user of the
CapsoAccess® system requires continued
operation during power mains
interruptions, it is recommended that the
CapsoAccess® system be powered from an
uninterruptible power supply or a battery.
Power frequency magnetic fields should be
at levels characteristic of a typical location
in a typical domestic, commercial or
hospital environment.