Transistor AutoMini Digital Manuel page 9

ENGLISH
Connection option D: Microphone (Extra accessory)
If the TV does not have an Optical, Line Out socket or SCART, use an FXT microphone
(ordered separately) to pick up the TV sound.
1. Connect the microphone to the amplifier's LINE/DIGITAL socket.
The DELAY knob should be in OFF mode.
2. Attach the microphone to the TV speaker with Velcro fastener.
Please note! The sound quality varies between different parts of the loudspeaker. Start
by placing the microphone in the centre of the loudspeaker. If you are not satisfied with
the sound, test to find out which microphone position gives the best sound.
3. Set the switch on the front of the amplifier to the LINE/DIGI position.
The relevant lamp will come on.
16
3. Connecting the listening loop
Select how you wish to listen to the sound. Wearers of hearing instruments can listen via
the chair loop supplied or via our neck loop which can be purchased as an accessory.
Listening option A: Chair loop
1. Turn the volume down to minimum (0) so that the sound level is not too
high at the outset. The DELAY knob should be in OFF mode.
2. Insert the chair loop connector in the amplifier's LOOP socket. The green
LOOP OK lamp comes on.
3. Place the chair loop on the seat, either below or above the seat cushion.
4. Lay the cord supplied along the wall. Make sure that the cord is positioned so
that you cannot trip up on it.
5. Set the hearing instrument to the T or MT position.
6. Adjust the volume control to a comfortable level and sit on the chair loop when
listening.
Listening option B: Neck loop (accessory)
Our neck loop with volume control is an alternative to the chair loop. Sold separately.
Fitted as set out in step 1 and 2 above and worn round the neck. Set the hearing instru-
ment to the T or MT position.
Synchronization of sound - the DELAY knob
Unsynchronized sound can be found in certain LED, LCD or PLASMA TV sets. If the
sound is not synchronized with the image (the sound precedes the image) you can adjust
this with the knob marked "DELAY" on the backside of AutoMini. Increase the delay
of the sound by turning the DELAY knob clockwise until you find that the sound is
synchronized with the image. This should only be needed to do once.
ENGLISH
17