Transistor AutoMini Digital Manuel page 8

ENGLISH
3.5 mm Audio output
1. Connect the 3.5 mm audio cord between the TV and the amplifier's
LINE/DIGITAL socket. The DELAY knob should be in OFF mode
2. Set the switch on the front of the amplifier to the LINE/DIGI position.
The relevant lamp will come on.
→ Proceed to step 3: "Connecting the listening loop", page 17.
If your TV does not have a Line Out or a 3.5 mm audio output, move on to connection option
→
C.
Please note! Some TVs have a sound input on the front or on the side which looks
like a Line Out output but which is NOT able to transmit soundt o an amplifier.
This is usually marked "Audio" and is located next to sockets marked "Video" and
"S-Video" (se TV user manual).
14
TV EXT
Connection option C: SCART connector (Extra accessory)
Check whether your TV has a SCART socket. It does not matter whether it is in
use.
--> If it does not have one, proceed to connection option D.
SCART socket
Connect the amplifier to the TV SCART socket using the SCART cord
1.
supplied. If the TV has more than one SCART socket, use the one that the TV
manual recommends for video (usually SCART 1 or AV1).
If the TV's SCART socket is being used by one or more external units (e.g. video,
DVD, digibox, satellite receiver), connect the amplifier between the TV and the exter-
nal units. The units which are connected to the TV should be connected in series (see
illustration above). The DELAY knob on the backside of AutoMini should be in OFF
mode.
2. Set the switch on the front of the amplifier to the TV EXT position. One of the lamps,
TV or EXT, will come on, depending on whether the TV or an external unit is being
used at present.
--> Proceed to step 3: "Connecting the listening loop", page 15.
Please note! When correctly connected, the TV picture and sound will automatically be
changed to the programme source you selected (e.g. video, DVD, digibox, satellite receiver).
If you are watching video, DVD, satellite TV or another external unit and then switch to a
standard analogue TV channel, in some cases you may, however, receive the wrong sound
on the TV. In that case switch off the external unit, or all the external units, to obtain the
correct sound. This phenomenon will never occur if you use connection options A, B or D.
MIC/LINE
ENGLISH
DVD
Video
Digibox
15