Default Setting; Programming - Becker Centronic UnitControl UCS520 Notice D'utilisation

Operating Instructions
Encoding switch setting:
1. Lower position
2. Lower position
3. Lower position
Programming the intermediate position
Prerequisite: The sun protection system is at the fi nal retracted position.
1. Press and hold the intermediate position programming button ▼.
2. Additionally press the EXTEND button until you reach the required intermedi-
ate position. Adjustments can be made using the RETRACT or EXTEND but-
ton.
3. Release the intermediate position programming button ▼. The intermediate
position has now been saved.
The control light will briefl y light up 3 times.
Deleting the intermediate positions
Press the intermediate position programming button ▼ for longer than 5 sec-
onds. The intermediate position has now been deleted.
The control light will briefl y light up 3 times.
Programming the fabric tensioning position
Prerequisite: The sun protection system is at the fi nal extended position.
1. Press and hold the fabric tensioning position programming button ▲.
2. Additionally press the RETRACT button until you reach the required fabric
tensioning position. Adjustments can be made using the RETRACT or EX-
TEND button.
3. Release the fabric tensioning position programming button ▲. The fabric
tensioning position has now been saved.
The control light will briefl y light up 3 times.
Deleting the fabric tensioning position
Press the fabric tensioning position programming button ▲ for longer than 5
seconds. The fabric tensioning position has now been deleted.
The control light will briefl y light up 3 times.
26

Default setting

Alarm signal function on
Drive controller
No function

Programming