Maintenance - GREENSTAR GS 6150 Mode D'emploi

F21
F22
F23
F24
F25
the guide bar from being caught in the cut.
A Log lying on the ground (F21)
Saw down halfway, then roll the
log over and cut from the opposite side.
A Log hanging off the ground (F22)
In area A, saw up from the bottom one-third and
finish by sawing down from the top. In area B, saw
down from the top one-third and finish by sawing up
from the bottom.
Cutting Limb of Fallen Tree (F23)
First check to which side the limb is bent.
Then make the initial cut from the bent side and
finish by sawing from the opposite side.
WARNING
!
Be alert to the springing back of a cut limb.
Pruning of Standing Tree(F24)
Cut up from the bottom, finish down from the top.
WARNING
!
Do not use an unstable foothold or ladder.
Do not overreach.
Dot not cut above shoulder height.
Always use your both hands to grip the saw.

9. MAINTENANCE

WARNING
!
Before cleaning, inspecting, or repairing your
unit, make sure that engine has stopped and is
cool. Disconnect the spark plug to prevent
accidental starting.
MAINTENANCE AFTER EACH USE
1.Air filter
Dust on the cleaner surface can be removed by
tapping a corner of the cleaner against a hard
surface. To clean dirt in the meshes, split the cleaner
in. o halves and brush in gasoline. When using
compressed air, blow from the inside.(F25)
2.Oiling port
Dismount the guide bar and check the
English