GREENSTAR GS 6150 Mode D'emploi page 37

WARNING
!
The saw chain has very sharp edges. Use thick
protective gloves for safety.
1. Pull the guard towards the front handle to check
that the chain brake is not on.
2. loosen the nuts and remove the chain cover.
3. Install the attached spike to the power unit.
4. Gear the chain to the sprocket and, while fitting
the saw chain around the guide bar, mount the
guide bar to the power unit. Adjust the position
of chain tensioner nut on the chain cover to the
lower hole of guide bar.(F2)
(8) Hole
(9) Tensioner nut
(10) Chain cover
NOTE
Pay attention to the correct direction of the saw
chain.(F3)
(1)Moving Direction
5. Fit the chain cover to the power unit and fasten the
nuts to finger tightness.
6. While holding up the tip of the bar, adjust the chain
tension by turning the tensioner screw until the tie
straps just touch the bottom side of the bar rail.(F4)
7. Tighten the nuts securely with the bar tip held up
(12~15N.m). Then check the chain for smooth
rotation and proper tension while moving it by hand.
If necessary, readjust with the chain cover loose.
8. Tighten the tensioner screw.
(2) Loosen
(3) Tighten
(4) Tensioner screw
English