Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
F13
F14
in the figure.(F12)
(1)Chain oil
The chain oil flow can be changed by inserting
a screwdriver in the hole on bottom of the clutch
side. Adjust according to your work conditions.
(F13)
(1) Adjuster
NOTE
The oil tank should become nearly empty by the
time fuel is used up. Be sure to refill the oil tank
every time when refueling the unit.
ADJUSTING CARBURETOR(F14)
The carburetor on your unit has been factory
adjusted, but may require fine tuning due to change
in operating conditions. Before adjusting the
carburetor, make sure that provided are clean
air/fuel filters and fresh, properly mixed fuel. When
adjusting, take the following steps:
NOTE
Be sure to adjust the carburetor with the
bar chain attached
1.Stop engine and screw in both H and L
needles until they stop. Never force. Then set them
back the initial number of turns as shown below.
3
H needle:
1 /
8
1
L needle:
1 /
4
2.
Start engine and allow it to warm up at
half-throttle.
3.
Turn L needle slowly clockwise to find a position
where idling speed is maximum, then set the
needle back a quarter(1/4) turn
counterclockwise.
4.
Turn idle adjusting screw(T) counterclockwise
to that saw chain does not turn. If idling speed is
too slow, turn the screw clockwise.
Publicité
Table des Matières
