Operating Engine; Starting Engine - GREENSTAR GS 6150 Mode D'emploi

F7
F8
F9
(5)
(3)
(4)
F10
(6)
F11
F12

7. OPERATING ENGINE

STARTING ENGINE

1. Fill fuel and chain oil tanks respectively,
and tighten the caps securely.(F7)
2. Put the switch to "l" position.(F8)
3. While holding the throttle lever together with the
throttle interlock, push in the side throttle lock button
and release the throttle lever to hold it at the starting
position.(F9)
(1) Chain oil
(2) Fuel
(3) Switch
(4) Throttle lever
(5) Throttle interlock
(6) Choke knob
Pull out the choke knob to the closed position.(F10)
4.
NOTE
When restarting immediately after stopping the
engine, leave the choke knob at the open position.
5.
While holding the saw unit securely on the
ground, pull the starter rope vigorously.(F11)
WARNING
!
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch your
body. It's very dangerous.
When engine has ignited first, push in the choke
6.
knob and pull the starter again to start the engine
Allow the engine to warm up with the throttle lever
7.
pulled slightly.
WARNING
!
Keep clear of the saw chain as it will start
rotating upon starting of engine.
CHECKING OIL SUPPLY
After starting the engine. run the chain at medium
speed and see if chain oil is scattered off as shown
English